派克T6H系列混和泵

T6H系列混和泵
混合泵的組合固定排量葉片泵B,C,D墨盒
結(jié)合一個變量墨盒PV20或PV29活塞泵。墨盒是由
一個共同的軸之間沒有耦合的他們有一個大常見的吸入口和兩個
三個獨立的出口港口:一個活塞,一個或兩個葉片泵
這些泵有非常緊湊的位移,在所有實際的泵的大小
市場。
T6H20B = 42,9 ml/rev variable + 5,8 to 50,0 ml/rev fixed
T6H20C = 42,9 ml/rev variable + 10,8 to 100,0 ml/rev fixed
T6H29B = 61,9 ml/rev variable + 5,8 to 50,0 ml/rev fixed
T6H29C = 61,9 ml/rev variable + 10,8 to 100,0 ml/rev fixed
T6H29D = 61,9 ml/rev variable + 47,6 to 158,0 ml/rev fixed
T6H29DB = 61,9 ml/rev variable + 47,6 to 158,0 ml/rev fixed + 5,8 to 50,0 ml/rev fixed
連續(xù)壓力等級變量位移單位T6H20B / C和240條
1. Check speed range, pressure, temperature, fluid quality, viscosity and pump rotation.
2. T6H pump case pressure should not exceed 0,7 bar (see datas).
3. Check inlet conditions of the pump, if it can accept application requirement.
4. Type of shaft : if it would support operating torque.
5. Coupling must be chosen to minimize pump shaft load (weight, misalignment).
6. Filtration : must be adequate for lowest contamination level.
7. Environment of pump : to avoid noise reflection, pollution and shocks.
8. Although the T6H pumps have fast off stroke compensator reponse, system relief 
valves are recommended for safety considerations.
9. When constantly under pressure with no flow requirements, it is safer to flush the piston 
pump. Three drains holes are there for this purpose.